Skip to content

DirecTV

Get Additional Gemini Devices

Click or Scan to Purchase Additional Boxes

DirecTV Channel Lineups

DirecTV Interactive Demo

Gemini & Remote FAQs

Click to reveal answers to each question below:

Here’s a step-by-step guide to install your DirecTV Gemini (or Gemini Air) streaming device on your TV:

Step 1: Unbox the device. Take out the Gemini device, HDMI cable (often attached), power adapter, and remote.

Step 2: Connect HDMI.  Plug the HDMI cable from the Gemini into an open HDMI port on your TV.

Step 3: Plug in power. Connect the power adapter to the Gemini device, then plug it into a wall outlet.

Step 4: Turn on TV.  Use your TV remote to power on the TV and switch to the correct HDMI input.

Step 5: Pair the remote. Remove the battery tab on the remote. Point it at the device and press/hold the Fast Forward (FF) and Rewind (RWD) buttons together until pairing starts.

Step 6: Follow on-screen setup.  Connect to your Wi-Fi (or use Ethernet if available), sign in with your DirecTV Stream account, and complete activation.

That’s it! The on-screen prompts will guide you through the rest of the set up. If issues arise, check your TV input or restart the device. For support call YellowHammer IT at (251) 200-5020 (Option 1 for Tech Support)

 Gemini runs entirely over your internet connection. Most playback issues are internet-related. If you experience buffering or freezing, follow these steps:

Step 1: Restart your modem/router (unplug for 30 seconds, then plug back in).

Step 2:  Restart the Gemini box (unplug for 15 seconds).

Step 3: Make sure the box is close enough to your WiFi router or consider a wired Ethernet connection for best performance. 

Follow the steps below:

Step 1: Press the Home button on the remote to access the main menu.

Step 2: Press the left arrow on your Gemini remote and then toggle down to apps, or simply press the “apps” button on the bottom right corner of your Gemini remote.

Step 3: Open your installed apps (Netflix, Prime, etc.)

Follow the steps below:

Step 1: Replace the batteries first.

Step 2: Make sure the remote is paired via Bluetooth (Settings > Remotes & Accessories).

Step 3: If needed, restart the Gemini box to re-sync the remote.